Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburettors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
- 10. Brake system
   10.1.2. Brake Pads forward brakes
   10.1.3. Brake Pads back brakes
   10.1.4. The general adjustment of back brakes (Girling)
   10.1.5. Replacement brake колодок (all-wheel drive models)
   10.1.6. The general adjustment of back brakes (Girling) (all-wheel drive models)
   10.1.7. Plugs of pedals of a brake and coupling
   10.1.8. Adjustment of a manual brake
   10.1.9. Removal of the lever of a manual brake
   + 10.2. Hydraulic components
   + 10.3. Antiblocking system of brakes
+ 11. A steering
+ 12. A body, salon
+ 13. A central air
+ 14. An electric equipment


32ad0625

10.1.2. Brake Pads forward brakes Check of a thickness brake колодок

PERFORMANCE ORDER
1) visually check up a thickness external колодок through apertures of a wheel disk (use a small lamp if it is necessary)
2) if a thickness колодок 7 mm or are less (together with a fixing plate), brake Pads have worn out to the limit of deterioration and it is necessary to replace them

Replacement brake колодок

PERFORMANCE ORDER
1) remove wheels

The prevention

If you gather establish old brake Pads, mark them at removal not to mix external and internal brake Pads and to establish them on that support from which they have been removed.


2) remove caps of directing pins (are specified by arrows)
3) remove both directing pins
4) remove a clamp of a brake hose from an arm on a rack of the bearing of a nave
5) turn a brake support upwards and fix it in such position
6) remove brake Pads
7) check up correctness of an arrangement of the thermal screen on the piston
8) press the piston back into the support cylinder

The prevention

Always merge a little a brake liquid from a tank before installation new brake колодок. At pressing in of the piston of a support in the cylinder, the liquid is pushed out from a support in a tank. After installation brake колодок, fill a tank to a mark the MOVE.


9) establish brake Pads
10) tighten directing pins of the case of a support to 25 Н.м.

11) establish caps of directing pins

12) establish a clamp of a brake hose on an arm on a rack of the bearing of a nave of a wheel

The prevention

Two самоконтрящихся a bolt from the repair complete set are not required at repair of brakes Teves. In a return case, use all repair set.

Strongly press a brake pedal some times at the motionless car that the piston of a support and brake Pads became into place.