Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation

Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburettors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. An exhaust system
- 7. Ignition system
   7.1.2. Specifications (4-cylinder models)
   7.1.3. Components of system of ignition for 5-cylinder models
   7.1.4. Specifications (5-cylinder models)
   7.1.5. The block of management CIS-E Motronic (the alarm block)
   7.1.6. A distributor rotor
   7.1.7. The ignition distributor (4-cylinder models)
   7.1.8. The ignition distributor (5-cylinder models)
   7.1.9. Components of system of ignition for 20-klapannyh models
   7.1.10. Specifications (20-klapannye models)
+ 8. Transmission
+ 9. Suspension brackets, wheels
+ 10. Brake system
+ 11. A steering
+ 12. A body, salon
+ 13. A central air
+ 14. An electric equipment


7.1.7. The ignition distributor (4-cylinder models)

The prevention

On a rotor there should be label R1 (for the cars equipped with the generator of the Hall).


1) And – at the established engine establish a flywheel in the top dead point – the cylinder 1
2) In – at the removed engine – establish a label on виброгасителе (pulley) opposite to a label on a belt cover
3) level a label on an asterisk of a cam-shaft with a cover of a head of cylinders (it is specified by an arrow)
4) level a cut of a ledge of a drive with a carving aperture

The prevention

The head of a tightening bolt of the distributor is closed by a seal which is necessary for removing if the distributor for any reason acts in film.

5) establish the distributor so that the rotor has been directed on a label for the cylinder 1 on a distributor casing
6) clear a distributor cover before installation, check up it about cracks and soot traces as result искрения, if necessary replace
7) adjust a corner of an advancing of ignition
8) tighten tightening a distributor bolt (25 Н.м.)
9) establish a new seal on a long bolt of the distributor

The prevention

At replacement of the block of management check up installation of a corner of an advancing of ignition, if necessary adjust.