Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburettors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Ignition system
- 8. Transmission
   8.1.2. A plug - the main cylinder of coupling
   8.1.3. Press a coupling disk
   8.1.4. Malfunctions of coupling
   - 8.2. A mechanical transmission 012
      8.2.2. The lever mechanism of the lever of a gear change
      8.2.3. Removal and transmission installation
      8.2.4. Differential mechanisms
   + 8.3. A mechanical transmission 01А
   + 8.4. An automatic transmission 089
   + 8.5. An automatic transmission 087
   8.6. Dismantling and assemblage of automatic transmissions
   8.7. The block of valves
   + 8.8. An automatic transmission 097
+ 9. Suspension brackets, wheels
+ 10. Brake system
+ 11. A steering
+ 12. A body, salon
+ 13. A central air
+ 14. An electric equipment


32ad0625

8.2.4. Differential mechanisms
THE GENERAL DATA

Differential in gathering

1. The differential case
At replacement of the case of differential adjust installation збчатого a wreath
2. A bolt of a gear wreath
Use bolts only the demanded specification
Tighten in regular intervals in a diagonal order to 90 Н.м.
3. The big roller bearing – an internal holder
To establish by means of the plug 40-21
4. A gear wheel of a drive of a speedometer
It is possible to remove, without removing a transmission
5. The big roller bearing – an external holder
Establish by means of tools VW 295 and VW 551
6. Washer S1, note a thickness
7. A cover
8. A persistent washer
Before installation grease трансмиссионным with oil
9. Satellites
10. An axis of satellites
Remove with the help выколотки after removal of a pin of an axis of satellites
11. A pin of an axis of satellites
Remove with the help выколотки
12. Gear wheels of semiaxes
13. A gear wreath
The gear wreath and leading gear wheel are adjusted to each other
At pair replacement a gear wreath / a leading gear wheel spend adjustment
Installation: heat up to 100 ° With and establish by means of centering pins
14. A small roller bearing – an internal holder
To establish by means of the plug 40-21
15. A small roller bearing – an external holder
16. Washer S2
Note a thickness